5.4.9
Set the unit for the accumulated or totalized flow rate
This function is to set the unit of accumulated flow. If one likes to switch between m
3
and SCF,
following the above-mentioned steps, at the MENU setting screen,
use the “Up” or “Down” key to select F3
1 - UnT-A
. Press the “M”
key to confirm, and it will open the sub-MENU showing the current
unit of accumulated flow
. Use the “Up” or “Down” and the “M”
confirming key to select the desired one, and press the “M” key
again to complete the task. The display will then return to the F31
–
UnT-A
screen, which indicates the task is completed. Use the “Up”
or “Down” key to select F99
-
qUIT and the “M” key t
o exit the
MENU and return to the Main Display screen.
5.4.10
Set the unit for the instant flow rate
This function is to set the unit for an instant flow rate. If one likes to switch between SLPM, m
3
/h
(m3PH), and SCFM, following the above-mentioned steps, at the
MENU setting screen, use the “Up” or “Down” key to select F3
2 -
UnT-F
. Press the “M” key to confirm, and it will open the sub
-
MENU showing the current unit of accumulated flow. Use the “Up”
or “Down” and the “M” confirming ke
y to select the desired one,
and press the “M” key again to complete the task. The display will
then return to the F32 - UnT-F screen, which indicates the task is
completed. Use the “Up” or “Down” key to select F99
- qUIT and
the “M” key to exit the MENU and return to the Main Display screen.
1
9
|
P
a
g
e
http://www.jetec.com w
om.tw/
.t
電話：
0
4
-
23729418 傳真：04-23724011 Email：[email protected] LINE：@jetec
MF5000 User Manual
