Assembly Instructions
Infeed and Outfeed Tables (Stock No. 98-2202)
for use with Model 22-44 Plus Drum Sander
Numbers in parentheses refer to Figure 2 and
the breakdown on reverse side.
1. Bolt the base bracket (2) to the sander with
two 3/8”-16 x 1” hex head cap screws (3)
and two 3/8” flat washers (4). Tighten the
screws.
2. Mount the table (1) to the base bracket (2)
with four 1/4"-20 x 3/4" carriage bolts (5),
four 1/4" flat washers (6) and four 1/4" hex
nuts (7).
Note:
Leave the carriage bolts
loose for now.
3. Place a straight edge on the conveyor bed
and extending out over the extension table.
Raise or lower the extension table until it is
level with, or slightly below, the surface of
the conveyor belt. Tighten the hex nuts (7).
4. Repeat for the opposite side.
Figure 1
Figure 2
JET
427 New Sanford Road
LaVergne, Tennessee 37086
Part No. M-98-2202
Ph.: 800-274-6848
Revision C2 01/2014
www.jettools.com
Copyright © 2014 JET
