8
MOUNTING THE MAST-R-FENCE III TO EMBEDDED TABLE TOP TRACKS
SETTING FENCE SCALES
NOTE: You will need to source a T-nut or hex nut with a
3
⁄
8
"-16 thread which matches the width of the T-slot
in your top.
NOTE: If you are mounting your Mast-R-Fence III with the provided tracks, please skip step 7.
Step 8:
Now that your fence is fastened to the fence tracks, you will need to align the fence to
the bit opening and adjust your scales accordingly.
a.
Ensure your router is mounted in the table top with a router bit
in your router.
b.
Loosen the clamping knobs (part # 5), and slide your fence so
it is centred around the router bit.
c.
Check that the fence is parallel to the front edge of the table.
d.
Tighten the fence clamping knobs.
Figure 11
Step 7:
Mounting your fence to in table T-slots
a.
Remove the (2) #10-24 X ½" pan head torx screws (part #3)
from each knob mount (part #7).
b.
Move the knob mount (part #7) to the pre-drilled holes in the
base (part #14).
See figure 10.
c.
Retighten the #10-24 X ½" torx screws to secure the knob
mount in place.
d.
Refer to step #6 for mounting the clamping knobs to the tracks.
3
7
5
4
6
Figure 10
6
4
5
3
7
3
7
Figure 9
3
7
