5
THE FOLLOWING INSTRUCTIONS ARE FOR MOUNTING THE #04400 MAST-R-FENCE III
TO A JESSEM MAST-R-TOP OR A JESSEM MAST-R-LIFT EXCEL II TOP
THE FOLLOWING INSTRUCTIONS ARE FOR MOUNTING THE #04400 MAST-R-FENCE III
TO A NON-JESSEM TOP
NOTE: If you are mounting your Mast-R-Fence III to a Non-JessEm top, please skip to step 2.
Step 1:
Securing fence mounting angles (part #20) to table top
a.
JessEm’s Mast-R-Top and Mast-R-Lift Excel II table tops are
pre-drilled for easy assembly.
b.
Using two wooden spacers, at least 2" high flip your table top
upside down on a table to raise the table off your working sur-
face a couple of inches.
See Figure 1.
c.
Position the left and right fence mounting angles on each side
of the table (part #20).
d.
With the #10-24 x ½" self tapping torx drive screws (part #19),
fasten and secure the fence mounting angle to the table.
See
Figure 1.
e.
Skip to step 3.
Figure 1
Step 2:
Marking and drilling your holes
a.
Take one of your fence mounting angles and with a pencil,
mark your holes on the underside of your table top, using the
fence mounting angle (part #20) as a template.
See Figure 2
.
NOTE: THE MOUNTING ANGLES SHOULD BE APPROXI-
MATELY 1-
1
⁄
4
"
FROM THE BACK OF THE TOP.
b.
Pre-drill the holes using a
1
⁄
16
" diameter drill bit and be sure you
do not drill through the table top surface. It is suggested you
use masking tape on your drill bit to prevent this.
c.
Secure the track mounting angles to the table top with the #10
wood screws you sourced. Repeat this step for the other side.
1-1/4"
MARK 4 HOLES ON EACH SIDE
20
Figure 2
NOTE: You will need to source (8) wood screws. The length of the screws will depend on the thickness of your
table top. Typically you would want screws that are about ¼" less than the thickness of your top. (Example: 1"
table top would require ¾" screws.)
NOTE: If you are mounting your Mast-R-Fence III to a JessEm top, please skip step 2.
19
20
20
