JESS WELDING SynMag 2600, Operating Instructions Manual

Page: 62 / 92

EN - 16
BA-0006 • 2020-02-08
7 Operation SynMag 2600/3100/3600/4100/5100
7.2 Operation
7.2.1 Setting the programme number
SynMag 2600/3100
1
Press and hold “Prog” (pos. G Button for displaying the programme number ) for about three seconds.
The “Prog. no.” LED flashes.
2
Press the button again to select the programme number based on the table.
3
The programme is adopted after about two seconds. The LED stops flashing.
SynMag 3600/4100/5100
1
Press and hold the “Prog” button (pos. F Button for displaying the programme number ) for about three
seconds. The “Prog. no.” LED flashes.
2
Press the button again to select the programme number based on the table.
3
The programme is adopted after about two seconds. The LED stops flashing.
7.2.2 Setting the material thickness
SynMag 2600/3100
1
Press and hold the “mm” button (pos. H Button for displaying the material thickness ) for about two
seconds.
2
Use the voltage selector switch ( E Welding voltage selector switch ) to set the desired material thickness.
3
The selected material thickness is indicated on the display (pos. L Indicator: programme number/
material thickness ).
SynMag 3600/4100/5100
Once the programme has been selected, the “mm” LED illuminates. The desired material thickness can be
set using the general voltage selector switch
(A) and precise voltage selector switch (D) . The thickness is
indicated on the display.
7.2.3 Operating modes
There are three operating modes available for MIG/MAG welding. These can be selected using button (D)
on the SynMag 2600/3100 and button (E) on the SynMag 3600/4100/5100 .
MIG/MAG spot welding, 2-step operation
SynMag 2600/3100
Use the knob in Fig. 12 pos. A on page EN-15 to set the spot welding time. The process sequence is as
follows:
• Step 1: Press and hold the torch trigger. The shielding gas flows. The arc ignites.
• Step 2: The arc automatically goes out after the set time has elapsed. The shielding gas continues to
flow for a brief period.
NOTICE
There is no characteristic for programme number “0”. The welding power must be set using the voltage
selector switch (pos.
E Welding voltage selector switch ) and the knob (pos. C WF speed knob ).
NOTICE
There is no characteristic for programme number “0”. The welding power must be set using the voltage
selector switches (pos.
A General voltage selector switch and D Precise voltage selector switch ) and the
knob (pos. C WF speed knob ).
CAUTION
The welding wire is live!
• The voltage selector switch must not be operated during the welding process!