JESS WELDING E4-2800 PULS RMT, Operating Manual

Page: 44 / 76

Page 42 Operating Manual E4-2800/4200/5200 / M4-3000/4000/5500 04/2014
8.4 MIG/MAG Synergic – Normal welding and brazing
One-knob operation
A voltage value is associated to the wire feed speed via a so-called synergy table.
1. Commissioning of the device (see chapter 7 )
2. Starting the device with the power switch (Pos. 5, Abb. 5.2)
3. Section Selection of welding process
Select
„Syn“
by pressing the key
4. Selection of characteristics
Selection according to the welding application
see section
5. Selection of welding parameters
Section Section
•
Selection of the desired wire feed speed via the rotary pushbutton (E). The right
display indicates the selected value in m/min. (Alternate setting via amperage resp.
plate thickness by pressing the key (E))
•
The left display indicates the value of arc length correction in %
•
Adjustment of arc length with the rotary pushbutton (V)
Factory setting: 0%
Longer arc: Turn the pushbutton (V) to m30%
Shorter arc: Turn the pushbutton (V) to maximum – 30%
•
Adjustment of choke setting:
Adjustment by pressing the rotary pushbutton (V))
Display flashes, % is displayed
Adjustment of choke values with rotary pushbutton (V)
Factory setting: 0%
Soft arc (higher choke effect): Turn the pushbutton (V) to m30%
Hard arc (less choke effect): Turn the pushbutton (V) to maximum -30%
6. Selection of advanced parameters (see chapter 6 )
7. Welding with the pre-set values
V
E
9
8
1
2