Jersey Jack Pinball Pirates of the Caribbean, Operation Manual, Page: 85 / 359

The POTC Menu System B-49
USB Update
Use the USB Update utility to apply a POTC delta software update to your game. Note: The
update must be downloaded from the JJP® support website ( https://www.jerseyjackpinball.com/
support/ ), using a separate computer. Copy the “potc_update” folder from your computer onto an
empty USB memory stick (i.e. it should be the only folder on the stick). Power up the game, open
the coin door, and use the diagnostics buttons to enter the USB Update utility; the LCD monitor will
display the screen shown on top in figure B35.
Locate the end of the USB extension cable, just inside the open coin door. Fully insert the USB stick
into the connector at the end of the cable (if your USB stick is equipped with an “in-use” light, it will
illuminate).
To attempt the USB delta update, press the Enter button. The game’s playfield will go dark for
approximately 15-30 seconds (depending upon the size of the update); the LCD monitor will
display the bottom, left screen in figure B35. You can abort the update process by pressing the
Back/Escape button. When the delta update is complete, the LCD monitor will display the bottom,
right screen in figure B35, prompting you to remove the USB stick and restart the game. Power the
game down, remove your USB stick from the end of the USB cable, then power the game back up
again. Once the game has rebooted, verify that the delta update installed successfully by
re-entering the POTC Menu System. The installed software version is displayed in the lower, right
hand corner of most menu system screens.
To exit the USB Update utility, press the Back/Escape button.
Figure B35. USB Update utility screens.