E-4
LOCATION OF CONTROLS
POWER REQUIREMENTS
This unit operates on 120V~ 60Hz and requires 1 x DC3V CR2032 Lithium battery (not included) for
clock backup during a power outage. Do not attempt to operate the radio on any other power source.
You could cause damage to the unit and void your warranty.
REPLACING BACKUP BATTERY
1. Remove the screw from the BATTERY DOOR and remove the battery compartment cover.
2. Install 1 brand new CR2032 Lithium 3V battery according to the polarity markings on the BATTERY
COMPARTMENT COVER.
3. Replace the battery compartment and tighten the screw to secure the compartment.
NOTE:
The unit will operate without a battery installed, but your time and alarm settings will be lost and
will have to be reset in the event of a power interruption or failure.
IMPORTANT:
Be sure that the battery is installed correctly. Wrong polarity may damage the unit and void the
warranty. For best performance and longer operating time, we recommend the use of good quality
alkaline battery.
Controls and Functions of Unit
1. On/Off/Source
Button
2. Preset /Time Set / Y-M-D Button
3. / Minute
Button
4. Tuning - / Hour
Button
5. / Alarm2 Button
6. Volume - / Alarm1 Button
7.Temp / DST Button
8.Dimmer/SET Button
9.Snooze / Time Zone/Sleep Button
10. LED Display
11. Infrared Sensor
12. Speaker
13. AC Power Cord
14. Battery Door
15. FM Wire Antenna
16. Aux In Jack
17. Temperature Sensor (For indoor
temperature only)
