E-10
•
If the automatic tuning does not stop on the exact frequency of the station, for example,
it stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning method to “fine tune” to
the exact frequency of the desired station.
HINTS FOR BEST RECEPTION:
To insure maximum FM tuner reception, unwrap and fully extend the EXTERNAL FM WIRE
ANTENNA for best FM radio reception.
To set / recall the radio presets
1. Press the ON/OFF button (#9) to turn on the JCR-225.
2. Press the
BUTTON or
BUTTON buttons (#5 or #4) to select the desired radio
station.
3. Press and hold the SET/MEM BUTTON (#8), “P01” will blink in the LED DISPLAY (#10).
4. Use
BUTTON or
BUTTON (#5 or #4) to select the desired preset number (P01-
P10)
5. Press the SET/MEM BUTTON (#8)) again to confirm the preset.
6. Repeat steps 2 through 5 to preset up to 10 stations.
7. To recall one of the preset stations already programmed, tap the SET/MEM BUTTON (#8)
repeatedly until you reach the desired preset number/radio station.
SLEEP OPERATION
The sleep timer allows you to turn the unit off after a designated time has elapsed.
1. Press the ON/OFF button (#9) to turn on the JCR-225.
2. Press the
BUTTON or
BUTTON buttons (#5 or #4) to select the desired radio
station.
3. Press the SLEEP BUTTON (#1) to enter sleep mode.
4. Repeatedly tap the SLEEP BUTTON (#1) to select the sleep timer 90 – 60 – 30 - 15 –
OFF (in minutes). The unit will play for the selected length of time then turn off
automatically.
5. To cancel the sleep timer, repeatedly tap the SLEEP BUTTON (#1) until the timer shows
OFF.
6. To turn the unit “Off” before the selected length of time, press the
BUTTON at any
time.
Notes:
To check the remaining sleep time, tap the SLEEP BUTTON (#1) once.
DIMMER OPERATION
In standby mode, press the SNOOZE/SLEEP/DIM BUTTON (#1) repeatedly to select one of
the three brightness settings (high, medium or low).
