Jensen A540 DiXL V-2203, Operating Instructions Manual

Page: 65 / 110

HMCflex Operating instructions
6/23 © ehb errors and omissions excepted Operating instructions.doc
2 Operating the HMCflex
2.1 Connection
The HMCflex is fixed to the floor using the clamps delivered with it or via the 3 x M6 screw fittings. The
electrical connection of the HMCflex is achieved using a 19-pole German socket of the HDP 26-24-19
SE type.
The HMCflex can be used as engine monitoring at conventional, as well as electronically regulated
engines. For conventional engines the engine parameters which can be supervised must be wired
according to above plan. For electronically regulated engines all of the engine expensive equipment
conveyed engine parameters can be called up over the engine CAN bus SAE J1939.
Low power contacts ehb cable code
1 oil pressure green 1 mm²
2 "D+" terminal (excitation) white 1 mm²
3 temperature brown 1mm²
4 tank level switch grey 1 mm²
5 terminal 31, GND, earth blue 1 mm²
6 solenoid HC black 1mm²
7 Auto/manual mode
Feeder off / Reverse valve on
orange 1 mm²
9 external stop / Bonnet switch grey / red 1 mm²
11 feeder green / white 1 mm²
13 terminal "W" green / grey 1 mm²
15 Reverse valve green / black 1 mm²
17 CAN-Low
RxD programming cutting side
(by software version 1.0 without
function)
brown twisted or
screened
19 CAN-High
TxD programming cutting side
(by software version 1.0 without
function)
White twisted or
screened
High power contacts
8 50f to starter motor purple 2.5 mm²
10 19/17 preheat yellow 2.5 mm²
12 19/17 preheat or ter. 15
(programmable)
yellow 2.5 mm² or
red 2.5 mm²
14 terminal "30", b brown 2.5 mm²
16 terminal "30", b brown 2.5 mm²
18 solenoid PC black 2.5 mm²