Jenn-Air RISE JDS1450ML, Owner'S Manual, Page: 21 / 56

21
Complete Installation (Natural Gas to Propane
Gas)
1. Refer to the “Make Gas Connection” section for proper
connection of the range to the gas supply.
2. Refer to the “Electronic Ignition System” section for proper
burner ignition and operation.
3. Refer to the “Adjust Flame Height” section for burner flame
adjustments.
IMPORTANT: You may have to adjust the low setting for each
cooktop burner.
Checking for proper cooktop burner flame is very important.
Natural gas flames do not have yellow tips.
4. Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
IMPORTANT: Make sure to save the orifices that have just been
replaced in the conversion.
Natural Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
1. Turn manual shutoff valve to the closed position.
A
B
C
A.
To range
B.
Shutoff valve (closed position)
C.
Gas supply line
2. Unplug range or disconnect power.
To Convert Gas Pressure Regulator (Propane Gas
to Natural Gas)
1. Move the range out about 1 ft (30.5 cm) from the wall.
2. Locate the gas pressure regulator at the lower right corner on
the back of the range.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
3. Unscrew the metal cover and unscrew the blue regulator cap.
Keep the washer in place.
A
B
A
C
A.
Metal cover
B.
Washer
C.
Blue regulator cap
4. Flip the blue regulator cap over and screw it back into the
metal cover.
A
B
A.
Propane gas position
B.
Natural gas position
5. Screw the metal cover securely back into place. Do not
overtighten.