25
4.
Apply masking tape to the end of a
⁹⁄₃₂
" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and
remove by turning it counterclockwise and lifting out. Set gas
orifice spud aside.
5.
Gas orifice spuds are stamped with a number on the side.
Replace the LP gas orifice spud with the correct Natural gas
orifice spud.
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart
NOTE:
Refer to the model/serial/rating plate located on the oven
frame behind the top right-hand side of the oven door for proper
sizing of spuds for each burner location.
6.
Place LP gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the LP gas orifice spuds in case of
reinstallation with LP gas.
7.
Replace the burner base.
8.
Replace the burner cap.
9.
Repeat steps 1 to 7 for the remaining burners.
10.
Replace the baking drawer. See the “Remove/Replace
Drawer” section.
Complete Installation (LP Gas to Natural Gas)
1.
Refer to the “Make Gas Connection” section for proper
connection of the range to the gas supply.
2.
Refer to the “Electronic Ignition System” section for proper
burner ignition and operation.
3.
Refer to the “Adjust Flame Height” section for burner flame
adjustments.
IMPORTANT:
You may have to adjust the low setting for each
cooktop burner.
Checking for proper cooktop, bake and broil burner flame is
very important. Natural gas flames do not have yellow tips.
4.
Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
A. Stamped number
Burner Rating
Color
Size (mm)
ID Number
19,000 BTU (ST)
White/Gray
1.84
184
17,000 BTU (ST)
N/A
1.75
175
17,000 BTU
White/Blue
1.90
190
15,000 BTU
White/Green
1.80
180
9,200 BTU
White/Black
1.35
135
8,000 BTU
White/Yellow
1.25
125
5,000 BTU
White/Orange
1.00
100
1,200 BTU
Black
0.52
52
A
B
C
D
XXX
A
IMPORTANT:
Make sure to save the orifices that have
just been replaced in the conversion.
