5
Cabinet Cut-Out Dimensions
and Specifications
Cut-out Height:
34
1
⁄
2
" minimum
Cut-out Width:
15"
Cut-out Depth:
24" minimum
Leveling Legs
Install leveling legs (located in the literature pack):
• With at least 2 people, tip ice maker backwards
until there is approximately 12" of clearance
between the floor and the ice maker.
• Screw one front leveling leg into the screw
impression found in each corner. Leveling legs
should be screwed in until snug.
•
One person should not attempt to tilt the ice maker
by themself. Have someone else assist to prevent
the ice maker from falling during leveling leg
installation.
WARNING
•
The ice maker should remain upright at least
30 minutes prior to plugging it in.
CAUTION
Level the Ice Maker
Using a carpenter’s level, check to be sure the ice
maker is level from side to side and from front to back.
Leveling adjustments can be made by turning the
leveling legs counter-clockwise to increase height and
clockwise to reduce height.
NOTE:
The ice maker should not wobble. Use shims
to add stability when needed.
• Secure the door and repeat the above
procedures to install the rear leveling legs.
24"
Min.
24
3
⁄
4
"
14
3
⁄
4
"
Water supply should enter
cutout from right rear wall.
Screw
Impressions
Bottom
of Unit
Floor Drain
15"
34
1
⁄
4
" Min.
Adjustable
to 35"
34
1
⁄
2
" Min.
to
35
1
⁄
4
" Max.
Locate outlet
on back wall
to local codes.
41007621 JA Ice Maker ENG 4/28/03 2:18 PM Page 5
