Jenn-Air JGCK424PS, Owner'S Manual

Page: 8 / 32

8
PROPANE GAS WC
Manifold Pressure 10" (25 mb)
Minimum Line Pressure 11" (27.4 mb)
Maximum Line Pressure 14" (34.9 mb), .5 psi (3.5 kPa)
IMPORTANT:
�
NEVER REUSE OLD CONNECTORS WHEN INSTALLING
THIS COOKTOP.
To reduce the likelihood of gas leaks, apply TEFLON ® tape or
a thread compound approved for use with propane or natural
gases to all threaded connections.
Apply a non-corrosive leak detection fluid to all joints and
fittings in the gas connection between the supply line shut-off
valve and the cooktop inlet.
Check for leaks, Bubbles appearing around fittings and
connections will indicate a leak.
If a leak appears, turn off supply line gas shut-off valve, tighten
connections, turn on the supply line gas shutoff valve, and
retest for leaks.
Never test for gas leaks with an open flame.
�
NEVER TIGHTEN TO MORE THAN 35 ft lbs OF TORQUE.
INSTALLATION
Prepare Cooktop for Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
1. Remove packaging materials and literature package from the
cooktop before beginning installation.
2. Remove Installation Instructions from literature pack and read
them thoroughly before you begin.
Install Cooktop
Step 1:
�
Before installing apply the foam tape.
�
A tape is provided to seal the cooktop edges to the countertop.
Apply tape near inner underside cooktop edge. Use tape
around the entire cooktop perimeter.
� Cut off excess where tape butt ends.
Step 2:
�
Insert the cooktop centered into the cutout opening.
�
Make sure the front edge of the counter top is parallel to the
cooktop. Make final check that all required clearances are met.
Step 3:
�
Four clamp brackets are provided with your unit.
�
After cooktop has been installed into the countertop, install the
brackets on the burner box as shown in figure.
� Install the clamp brackets on the front and back of the burner
box bottom (if the cabinet construction does not provide
clearance for installing brackets at the burner box front back
install the clamp brackets on the lateral position of burner box).
Step A:
Place the clamping screws into brackets.
Step B:
Attach brackets by using the attachment screws on the
selected location of burner box, tighten screws just enough to hold
brackets in place step C position brackets so that they are with the
clamp screw in contact with the counter top bottom.
Step C:
Tighten attachment screws securely.
Step D:
Check that the front edge of the cooktop is parallel to the
front edge of the countertop tighten the screw clamping against
the countertop.
NOTE
:
Do not over tighten.