Jenn-Air JGCK424PS, Owner'S Manual

Page: 13 / 32

13
3. Replace the cap regulator.
A
B
D
C
E
F
G
H
A.
Cap
B.
Gasket
C.
Natural gas position
D.
Propane gas position
E.
Pressure regulator
F.
Plug
G.
Natural gas plug
H.
Propane gas plug
NOTE:
Before replace the regulator cap.
Check the position of plug.
Suitable for the gas converted.
Low Flame Height Adjustment
Light a match and hold the flame near the burner you want to light.
Wooden matches work best. Push in and turn the control knob
slowly. Be sure you are turning the correct knob for the burner you
are lighting.
NOTE: If the burner does not light within five seconds, turn the
knob off and wait one minute before trying again.
This appliance is shipped from the factory with low and medium
flame settings adjusted. If further adjustment is necessary,
proceed as follows:
Adjustment for Burners with one or two rings flame:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Insert a slender, thin-blade screwdriver into the recess at
centre of valve stem and engage blade with slot in adjusting
screw.
4. Turn center stem adjusting screw to set flame size:
� Clockwise to reduce
�
Counterclockwise to increase
5. Replace control knob when adjustment is completed.
Low flame adjustment
One or two rings flame
A
A.
Valve stem
� Counterclockwise to increase flame size
�
Clockwise to reduce flame size
Proper adjustment will produce a stable, steady blue flame of
minimum size.
The final adjustment should be checked by turning knob from high
to low several times without extinguishing the flame. This
adjustment, at low setting, will automatically provide the proper
flame size at medium setting.
After Conversion steps have been completed, check the
appearance of each burner’s flame at the HI and LO settings, if
the flames appear too large or too small review each step to make
sure it was completed correctly.
NOTE: To obtain the correct minimum setting with propane gas,
turn clockwise tightening the valve fully by the thin-blade
screwdriver into the recess at centre of valve stem.
Electric gas ignition
The gas burner use an electric ignition device located near each
burner that by means a spark igniters ensure its surface light
automatically.
The Burner Flames
Turn each burner on. Flames should be blue in color with no trace
of yellow. The burner flames should not flutter or blow away from
the burner. The inner cone of the flame should be between 1/2"
(1.27 cm) and 3/4" (1.91 cm) long.
A
B
A.
1/2" (1.27 cm) to 3/4" (1.91 cm)
B.
Cooktop burner