F7screen: Marking the special character/ Install the projected file
F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
LOAD TO [USR1] FONT
STATUS [ ]
[FONT LOAD]
F7 : PLOT LOAD
FILENAME DATA TIME
>< NO FILE >
<Installation of user font>
If you press F7, you can move <<FONT LOAD>>, press F7F7, you can move <<PLOT LOAD>>
And then go to F3 and change FONT: STD to USER1, after move to F7 screen, use tab key
and bring the file.
After use direction key and select the Font and then press
“
ENTER
”
, you can use USER Font
Of MCU.If it is OK, you can show the signal
“
READ OK
”
in status block.
F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
LOAD TO [USR1] FONT
STATUS [ ]
[FONT LOAD]
F7 : PLOT LOAD
FILENAME DATA TIME
< NO FILE >
COLUMBIA.BLK 1998/06/05 12:45
MARKSMAN.BLK 1998/06/05 12:45
JEILMTECH.BLK 1998/06/05 12:45
Make the PLT file that a design and a letter in AUTO CAD from printer and then load it to controller
Mark by SD card. First of all, select one among PLT1~PLT4, and then move to below list item and find
the file. If you press the
“
enter
”
, it will be load.
(Change the marking format to PLT later on F3, if you adjust a letter size, you can adjust the size.)
F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
LOAD TO [PLT1] PLOT
STATUS [ ]
[PLOT LOAD]
F7 : FONT LOAD
FILENAME DATA TIME
>< NO FILE >
28