But in that case operating by PLC BINARY, it marks according to PLC signal.
MARK UP TO: This function allows you to set a number of how many pieces of your product to be marked.
If you set this number as mark up to [00000100] and when reached this number,
the system will stop automatically the marking operation.
EX) MARK UP TO: [00000100] = Marking machine marks the data until 100, and then it outputs alarm signal
From [00000101].
UNIT NO: This menu is a counter. It indicates the marking quantity.
09:30:31: Indicate the present time.
At multimode screen
F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
BLK NO. [ 00.00 ]
PLC INPUT SIGNAL [ . . . . . . . . ] [ . . . . . . . . ]
15:15:22 STATUS [ ]
[AUTO MARKING MODE]
F9 : SIMULATION F10 : MARK F11 : HOME
MARK_UP_TO[ 00000000 ] UNIT_NO[00001713]
< CURRENT DATA >
z
According to mode, each state is shown differently.
<Explanation of multi block mode of F2 screen>
When you get the products at first, F2 screen is to assign single block same as below.
F1 : M_MENU F2 : A_MARK F3 : EDIT F4 : FILE
F5 : SETUP F6 : TEST F7 : LOAD F8 : COMM
BLK NO. [ 000 ]
PLC INPUT SIGNAL [ . . . . . . . . ] [ . . . . . . . . ]
15:15:22 STATUS [ ]
[AUTO MARKING MODE]
F9 : SIMULATION F10 : MARK F11 : HOME
MARK_UP_TO[ 00000000 ] UNIT_NO[00001713]
< CURRENT DATA >
JEIL MTECH
In case of need to several lines marking with only one signal of PLC, though inefficient if give a
Point of contract each to the block. If you make subordinate block to main signal block, you can do
Hard work easily.
12