WWW.JEIUK.COM
RAILBEAST ELECTRIC RDE-36
This document is protected by copyrights.
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.
8
3. STARTUP AND OPERATION
3.1. Installing and removing the annular cutter
With the motor stopped, turn the handles (
1
) to move out the arbor. Install the arbor
as described before. Use gloves to put the correct pilot pin into the annular cutter (
2
).
Use a dry cloth to clean the cutter. Put the cutter into the arbor (
3
) to align the flat
surfaces (
4
) with the screws (
5
). Use the 4 mm hex wrench to tighten the screws.
To remove the cutter, loosen the screws (
5
) with the 4 mm hex wrench.
3
5
4
1
2
