USER MANUAL
v.1.1
JEFTRCH27-GY, JEFTRCH27-GN, JEFTRCH27-OR
10W COB LED Rechargebale Inspection Lamp
www.jeffersontools.com
1
INTRODUCTION
•
High quality 10W (800Lumens) COB LED inspection lamp with 3W LED directional torch
•
USB rechargeable li-ion battery
•
Strong magnetic plates on the rear of the housing and base allow for flexible positioning in your
workspace for easy hands-free operation
•
Swivel and tilt functionality allows the lamp to be rotated 360° and lilted through 90° allowing you
adjust the angle of illumination as required
•
Heavy-duty, ergonomic housing with IK10 impact rating and IP65 ingress protection
•
Powerful, reliable & durable 10W COB LED provides up to 800L luminosity with superior quality,
efficiency and light density compared with other standard LED technologies
SPECIFICATIONS
Model Number:
JEFTRCH27-GY, JEFTRCH27-GN, JEFTRCH27-OR
Luminosity:
10W COB LED Lamp
3W LED Torch
800 Lumens (High)
400 Lumens (Low)
160 Lumens
Operating Time:
2 Hours (High)
4 Hours (Low)
7 Hours
Charging Time:
4 Hours
Impact Rating:
IK10
Ingress Protection:
IP65
Battery:
Li-ion 18650 3.7V 4000mAh
Weight:
488g
Dimensions:
51 x 49 x 241mm
SAFETY
•
Warning: Bright light DO NOT shine directy into the eyes.
•
The lamp must only be used on flat, stable surfaces which are clean and free from dust, debris or grease.
•
This equipment should never be immersed in water or other liquids.
•
Do not operate with wet or greasy hands.
•
Do not cover the lamp during operation.
•
Must never be operated with an open housing, missing or damaged wiring, compartment, or missing or damaged lens.
•
Must never be sprayed or cleaned using a steam pressure cleaner since this can damage the insulation and seals.
•
Must never be repaired by the user, repairs must only be carried out by the manufacturer or an authorized service representative.
OPERATION
The inspection lamp has four switching settings: Press once on the ON/OFF switch at the rear of the housing to go to the next setting. The following
settings are available:
1.
COB Half power (400 Lumens)
2.
COB Full power (800 Lumens)
3.
3W Torch ON
4.
3W Torch OFF.
To position the lamp using swivel and tilt:
1.
Grip the lamp housing and base simultaneously, then rotate magnetic base through 360°.
2.
Grip the lamp housing and base simultaneously, then pull upward to allow pivoting 90° horizontally on the pivoting base.
Charging:
The lamp should be partially charged when first unpacked. Charge the product fully before operation using the USB charge cable supplied.
Do not use the lamp when charging. Do not use a modified or damaged charger. Do not leave the lamp charging over the charging time.
Cleaning:
Allow the light to cool down sufficiently. Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required.
Do not use cleaners that contain abrasives or solvents.
