STARTING AND OPERATING
155
An advantage of the higher ground clearance is
a better view of the road, allowing you to
anticipate problems. They are not designed for
cornering at the same speeds as conventional
passenger cars any more than low-slung sports
cars are designed to perform satisfactorily in
off-road conditions. Avoid sharp turns or abrupt
maneuvers. As with other vehicles of this type,
failure to operate this vehicle correctly may
result in loss of control or vehicle rollover.
O
FF
-R
OAD
D
RIVING
T
IPS
When To Use 4WD LOW Range
When off-road driving, shift to 4WD LOW for
additional traction and control on slippery or
difficult terrain, ascending or descending
steep hills, and to increase low-speed pulling
page 106. This range should be
limited to extreme situations such as deep
snow, mud, or sand where additional low
speed pulling power is needed. Vehicle speeds
in excess of 25 mph (40 km/h) should be
avoided when in 4WD LOW.
Driving Through Water
Although your vehicle is capable of driving
through water, there are a number of
precautions that must be considered before
entering the water:
Driving through water more than a few inches/
centimeters deep will require extra caution to
ensure safety and prevent damage to your
vehicle. If you must drive through water, try to
determine the depth and the bottom condition
(and location of any obstacles) prior to entering.
Proceed with caution and maintain a steady
controlled speed less than 5 mph (8 km/h) in
deep water to minimize wave effects.
Flowing Water
If the water is swift flowing and rising (as in
storm run-off) avoid crossing until the water
level recedes and/or the flow rate is reduced. If
you must cross flowing-water, avoid depths in
excess of 9 inches (22 cm). The flowing water
can erode the streambed causing your vehicle
to sink into deeper water. Determine exit
point(s) that are downstream of your entry point
to allow for drifting.
Standing Water — Trailhawk Only
Avoid driving in standing water deeper than
19 inches (48 cm), and reduce speed
appropriately to minimize wave effects.
Maximum speed in 19 inches (48 cm) of water
is less than 5 mph (8 km/h).
Maintenance
After driving through deep water, inspect your
vehicle fluids and lubricants (engine,
transmission, Power Transfer Unit and Rear
Drive Module) to ensure they have not been
contaminated. Contaminated fluids and
lubricants (milky, foamy in appearance) should
be flushed/changed as soon as possible to
prevent component damage.
CAUTION!
When driving through water, do not exceed
5 mph (8 km/h). Always check water depth
before entering as a precaution, and check all
fluids afterward. Driving through water may
cause damage that may not be covered by
the New Vehicle Limited Warranty.
4
21_BV_OM_EN_USC_t.book Page 155