To Set The Variance
Start the engine and leave the transmission
gear selector lever in the PARK position. Press
and hold the RESET button on the steering
wheel (for approximately ten seconds) until the
current variance zone number is displayed. To
change the zone, press and release the STEP
button to increase the variance one step. Re-
peat as necessary until the desired variance is
achieved.
NOTE:
The factory default zone is 8. During pro-
gramming, the zone value will wrap around
from zone 15 to zone 1.
Manual Compass Calibration
If the compass appears erratic, inaccurate or
abnormal, you may wish to calibrate the com-
pass. Prior to calibrating the compass, make
sure the proper zone is selected.
1. Start the engine and leave the transmission
in the PARK position.
2. Press and hold the RESET button (for ap-
proximately 10 seconds) until the current vari-
ance zone number is displayed.
3. Release the RESET button, then press and
hold again for approximately 10 seconds, until
the direction is displayed, with the CAL indicator
on continuously in the display.
4. To complete the compass calibration, drive
the vehicle in one or more complete 360–
degree circles, under 5 mph (8 km/h) in an area
free from power lines and large metallic objects,
until the CAL indicator turns off. The compass
will now function normally.
NOTE:
•
A good calibration requires a level sur-
face and an environment free from large
metallic
objects
such
as
buildings,
bridges, underground cables, railroad
tracks, etc.
•
Magnetic materials should be kept away
from the top of the center of the instru-
ment panel. This is where the compass
sensor is located.
Average Fuel Economy / Distance To
Empty (DTE) / Elapsed Time
•
Average Fuel Economy
Shows the average fuel economy since the last
reset. When the fuel economy is reset, the digits
will go blank while the history information is
erased. The averaging will restart when enough
new distance and fuel data is accumulated.
•
Distance To Empty (DTE)
Shows the estimated distance that can be trav-
eled with the fuel remaining in the tank. This
estimated distance is determined by a weighted
average of the instantaneous and average fuel
economy, according to the current fuel tank
level. DTE cannot be reset.
•
Elapsed Time
Shows the total elapsed time of travel since the
last reset. Elapsed time will increment when the
ignition switch is in the RUN or START posi-
tions. The elapsed timer displays minutes:sec-
onds. After 59minutes:59seconds, it displays
hours:minutes:seconds.
173
PAGE POSITION: 175 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1