8. Using the plastic reinforcement as a handle
remove the tether strap from the bracket hook
by sliding strap up off hook and slide down the
side bow (both sides).
9. Button the side bow tether strap (both sides).
10. Remove the swing gate bar (black metal
bar for bottom of rear window) and set aside.
NOTE:
Be sure the wire harness in the left rear
corner is not tangled in the soft top bows
before you lift the top.
11. Unsnap and remove the black boot cover.
This cover should be discarded. It was intended
as a protective cover for shipping only.
NOTE:
A visual instruction sheet is enclosed in the
dual top wrap.
12. Put up the soft top. Refer to “Soft Top —
Putting Up The Soft Top” in this section.
FREEDOM TOP™
THREE-PIECE MODULAR
HARD TOP — IF EQUIPPED
CAUTION!
•
The hard top is not designed to carry any
additional loads such as roof racks, spare
tires, building, hunting, or camping sup-
plies, and/or luggage, etc. Also, it was not
designed as a structural member of the
vehicle, and thus cannot properly carry
any additional loads other than environ-
mental (rain, snow, etc.).
•
Do not move your vehicle until the top has
been either fully attached to the windshield
frame and bodyside, or fully removed.
107
PAGE POSITION: 109 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1