Jeep GRAND CHEROKEE 4xe 2023, Owner'S Manual

Page: 212 / 440

210 STARTING AND OPERATING
13. Push the ENGINE START/STOP button twice
(without pressing the brake pedal), to turn the
ignition to the OFF position.
14. Attach the vehicle to the tow vehicle using a
suitable tow bar.
15. Release the Electric Park Brake. Ensure
vehicle is in RUN position with the engine off.
16. Turn the ignition to the ON/RUN position, but
do not start the engine.
17. Confirm that the steering column is unlocked.
18. Disconnect the negative battery cable, and
secure it away from the negative battery post.
NOTE:

Disconnecting your vehicle battery will
erase radio presets and may affect other
vehicle settings. It may also trigger various
fault codes, causing MIL illumination when
the battery is reconnected.

If the vehicle is equipped with Quadra-Lift
air suspension, the engine should be
started and left running for a minimum of
60 seconds (with all the doors closed) at
least once every 24 hours. This process
allows the air suspension to adjust the
vehicle’s ride height to compensate for
temperature effects. You will need to recon-
nect the battery to perform this task. Once
the vehicle’s ride height has been adjusted
then you will need to ensure that you repeat
steps 16 through 18.
Shifting Out Of Transfer Case N (NEUTRAL)
Use the following procedure to prepare your
vehicle for normal usage:
1. Bring the vehicle to a complete stop, leaving
it connected to the tow vehicle.
2. Reconnect the negative battery cable.
3. Apply the Electric Parking Brake.
4. Turn the ignition to the OFF position.
5. Place the vehicle in Ready to Drive mode.
NOTE:

Steps 1 through 5 are requirements that
must be met before pushing the N
(NEUTRAL) button, and must continue to be
met until the shift has been completed. If
any of these requirements are not met
before pushing the N (NEUTRAL) button or
are no longer met during the shift, the N
(NEUTRAL) indicator light will flash continu-
ously until all requirements are met or until
the N (NEUTRAL) button is released.

The ignition must be in the ON/RUN position
for a shift to take place and for the position
indicator lights to be operable. If the ignition
is not in the ON/RUN position, the shift will
not take place and no position indicator
lights will be on or flashing.

A flashing N (NEUTRAL) position indicator
light indicates that shift requirements have
not been met.
6. Press and hold the brake pedal.
7. Shift the transmission into NEUTRAL.
8. Using a ballpoint pen or similar object, push
and hold the recessed transfer case N
(NEUTRAL) button (located by the selector
switch) for more than five seconds.
N (NEUTRAL) Button
23_WL_H_OM_EN_EE_t.book Page 210