Jeep GLADIATOR 2022, Owner'S Manual

Page: 336 / 380

CAUTION!
Do not touch the new bulb with your fingers. Oil con-
tamination will severely shorten bulb life. If the bulb
comes in contact with any oily surface, clean the bulb
with rubbing alcohol.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are
replaced as an assembly. See an authorized dealer for
service.
REAR TAIL, STOP, TURN SIGNAL, AND
BACKUP LAMP
NOTE:
Your vehicle may be equipped with LED bulbs, please
see an authorized dealer for LED bulb replacement.
See the following steps to replace:
1. Remove the two screws that pass through the bed
sheet metal.
2. Pull the outboard side of the lamp rearward, far
enough to unsnap the two receptacles on the out-
board side of the lamp housing, from the two plastic
snap post retainers in the outer box side panel.
3. Remove the screws from assembly bracket to
access the three bulb sockets.
4. Rotate the appropriate socket a quarter turn coun-
terclockwise, then remove it from the housing.
5. Pull the bulb straight from the socket to replace.
CENTER HIGH MOUNTED STOP LAMP
(CHMSL)
The stop lamp is mounted on the tailgate. If service is
needed, obtain the LED assembly from an authorized
dealer.
LICENSE PLATE LAMPS
See an authorized dealer to replace LED lamps.
See the following steps to replace:
NOTE:
To install a new bulb, reverse the procedure above.
When installing the new bulb, care should be taken to
not allow bare skin to come in contact with the bulb.
TIRES
TIRE SAFETY INFORMATION
Tire safety information will cover aspects of the follow-
ing information: Tire Markings, Tire Identification Num-
bers, Tire Terminology and Definitions, Tire Pressures,
and Tire Loading.
Tail Lamp Screws
Assembly Bracket
334 SERVICING AND MAINTENANCE