Jeep GLADIATOR 2022, Owner'S Manual

Page: 23 / 380

NOTE:
•
The vehicle must be equipped with an automatic
transmission to be equipped with Remote Start.
•
Obstructions between the vehicle and the key fob
may reduce this range.
•
The Remote Start system will wait for the Wait To
Start yellow telltale to extinguish before cranking the
engine
page 112. This allows time for the
engine preheat cycle to heat the cylinder air, and is
normal in cold weather.
WARNING!
•
Do not start or run an engine in a closed garage or
confined area. Exhaust gas contains carbon mon-
oxide (CO) which is odorless and colorless. Carbon
monoxide is poisonous and can cause serious
injury or death when inhaled.
•
Keep key fobs away from children. Operation of the
Remote Start system, windows, door locks or other
controls could cause serious injury or death.
HOW TO USE REMOTE START
Push and release the Remote Start button on the key
fob twice within five seconds. The vehicle doors and
tailgate will lock, the turn signals will flash twice, and
the horn will chirp twice. Pushing the Remote Start but-
ton again will shut the engine off.
NOTE:
•
With Remote Start, the engine will only run for
15 minutes.
•
Remote Start can only be used twice.
•
If an engine fault is present or fuel level is low, the
vehicle will start and then shut down in 10 seconds.
•
The parking lights will turn on and remain on during
Remote Start mode.
•
For security, power window operation is disabled
when the vehicle is in the Remote Start mode.
•
The ignition must be placed in the ON/RUN position
before the Remote Start sequence can be repeated
for a third cycle.
All of the following conditions must be met before the
engine will remote start:
•
Gear selector in PARK
•
Doors closed
•
Hood closed
•
Hazard switch off
•
Brake switch inactive (brake pedal not pressed)
•
Battery at an acceptable charge level
•
Panic button not pushed
•
Fuel meets minimum requirement
•
System not disabled from previous Remote Start
event
•
Vehicle Security system not active
•
Malfunction Indicator/Check Engine telltale is not
illuminated
•
Water In Fuel telltale is not illuminated
•
Wait To Start telltale is not illuminated
For additional Remote Start information, see
page 19.
VEHICLE SECURITY SYSTEM —
IF EQUIPPED
The Vehicle Security system monitors the vehicle doors
for unauthorized entry and the ignition switch for unau-
thorized operation. When the system is activated, the
interior switches for door locks are disabled. The
Vehicle Security system provides both audible and vis-
ible signals. If something triggers the alarm, the Vehicle
Security system will provide the following audible and
visible signals: the horn will pulse, the parking lights
and/or turn signals will flash, and the Vehicle Security
Light in the instrument cluster will flash.
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security system:
1. Make sure the vehicle’s ignition is placed in the OFF
position.
2. Perform one of the following methods to lock the
vehicle:
○
Push the lock button on the interior power door
lock switch with the driver and/or passenger
door open.
○
Push the lock button on the exterior Passive
Entry door handle with a valid key fob available
in the same exterior zone
page 23.
○
Push the lock button on the key fob.
3. If any doors are open, close them.
NOTE:
The Vehicle Security system will not arm if you lock the
doors using the manual door lock.
GETTING TO KNOW YOUR VEHICLE 21
2