Jeep 2020 RENEGADE, Owner'S Manual

Page: 84 / 484

82 GETTING TO KNOW YOUR INSTRUMENT PANEL
Unless reset, this message will continue to
display each time the ignition is cycled to the ON
or RUN position. To reset the oil change
indicator system (after performing the
scheduled maintenance), refer to the following
procedure:
1. Without pushing the brake pedal, push the
ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (do not
start the engine).
2. Fully push the accelerator pedal, slowly,
three times within 10 seconds.
3. Without pushing the brake pedal, push the
ENGINE START/STOP button once to return
the ignition to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator
system did not reset. See an authorized dealer
to have the oil life reset.
Instrument Cluster Display Menu Items
NOTE:
The instrument cluster display menu items
display in the center of the instrument cluster.
Menu items may vary depending on your vehicle
features.
Speedometer
Push and release the up or down arrow button
until the speedometer is displayed in the
instrument cluster display. Push and release
the OK button to toggle units (mph or km/h) of
the speedometer.
Vehicle Info
Push and release the up or down arrow button
until “Vehicle Info” is highlighted in the
instrument cluster display. Push and release
the right arrow button and Coolant Temp will be
displayed. Push the right or left arrow button to
scroll through the following information
displays:

Tire Pressure — View the information relating
to the Tire Pressure Monitoring System (If
Equipped).

Coolant Temperature — View the engine
coolant temperature.

Trans Temperature — View the trans oil
temperature.

Oil Temperature — View the oil temperature.

Battery Voltage — View the voltage value
(state of charge) of the battery.

Service — View the service status message(s)
(If Equipped).
Driver Assist — If Equipped
Push and release the up or down arrow button
until the Driver Assist menu title displayed is
highlighted in the instrument cluster display.
LaneSense — If Equipped
The instrument cluster display displays the
current LaneSense system settings. The
information displayed depends on LaneSense
system status and the conditions that need to
be met.
20_BV_OM_EN_USC_t.book Page 82