Jeep 2015 Renegade, Owner'S Manual, Page: 370 / 668

If an obstacle is detected in the left and/or right rear
region, the display will show a single flashing arc in the
left and/or right rear region and will produce a fast
sound tone. As the vehicle moves closer to the obstacle,
the display will show the single arc moving closer to the
vehicle and the tone will change from fast to continuous.
In general, the car is closest to the obstacle when the
display shows only a flashing arc and the chime becomes
continuous.
The color on the display depends on the distance and
location of the obstacle.
Enabling And Disabling Rear Park Assist
Rear Park Assist can be enabled and disabled with the
Rear Park Assist switch.
When the Rear Park Assist switch is pressed to
disable the system, the instrument cluster will
display the “PARK ASSIST OFF” message for
approximately five seconds. Refer to “Electronic Vehicle
Information Center (EVIC)” or “Driver Information Dis-
play (DID)” in “Getting To Know Your Instrument Panel”
for further information. When the shift lever is moved to
REVERSE and the system is disabled, the EVIC/DID will
display the “PARK ASSIST OFF” message for as long as
the vehicle is in REVERSE.
The Rear Park Assist switch LED will be ON when Rear
Park Assist is disabled or requires service. The Rear Park
Assist switch LED will be OFF when the system is
enabled. If the Rear Park Assist switch is pushed, and
requires service, the Rear Park Assist switch LED will
blink momentarily, and then the LED will be ON.
Rear Park Assist will remember the previous state when
the vehicle is switch off.
368 STARTING AND OPERATING