T464 Installation and Setup
20090709 v1r0 JED Microprocessors Pty. Ltd. - Page 7 of 27
Accessing the Setup Menu
•
Connect the T460/T464 Software Upload Cable to the ‘Projector 0’
socket.
•
Apply power.
•
Hit backspace to enter setup mode.
The following text should appear:
JED Microprocessors Pty. Ltd.
[RED Usage Notes do not appear on the terminal]
HW: 464v2r0
[T460 hardware version]
SW: v1r4 [<build information>]
[T460 software version installed.]
h: Show help
a: Network parameters
i: Show input state
j: Change user level
k: Input Special Notes. 80 characters max. Hit enter to store.
l: Input Location Information. 80 characters max. Hit enter to store.
v: Load Semi-static data from T460 on reboot.
ESC: Exit via Software Restart
Enter Function - [h(elp) - a|i|j|k|l|v|ESC]:
Monitor Text
Note:
The Setup Menu will exit via a restart and the T464 will resume
normal operation if:
•
The user hits the ESC key, or
•
No user input is detected for longer than sixty seconds.