T464 Installation and Setup
20090709 v1r0 JED Microprocessors Pty. Ltd. - Page 6 of 27
T464 Configuration
Hardware Required
•
PC or Notebook with Serial port or USB to Serial adapter.
•
T460/T464 Software Upload Cable.
•
Appropriate DC power source for T460/T464.
A serial terminal is required to configure T464. Usually, a PC or notebook
running serial terminal application software is employed. There are a number
of serial terminal applications that may be downloaded from the internet at no
cost.
is one example of a Windows application.
(Bray Terminal quirk: ‘ESC’ key clears output screen).
Note:
If nothing better is available, HyperTerminal may be used, but
expect to have to close and restart this application if it becomes
unresponsive. A Windows XP security patch broke HyperTerminal
years ago. HyperTerminal is not distributed with current Windows
operating systems.
The socket used to access the setup menu is an RS232 port, labelled
PROJECTOR 0. A USB to RS232 converter will be required if the serial
terminal does not have an RS232 port. A T460/T464 software upload cable is
used to connect the T464 to the terminal.
Configuration Interface
The setup menu provides a means to assign values to various parameters
which allow the T464 operation to be customised to suit a particular
installation. These values are stored in memory that is not affected by loss of
power.
Serial Terminal Settings
The following serial terminal parameters are used to access the setup menu:
•
115200 baud
•
8 bit data
•
1 stop bit
•
No parity
•
No handshake
•
Display 80 columns (Change font size as required).