JDS Uniphase SmartClass E1, User Manual

Page: 40 / 144

Chapter 3 Basic Testing
Managing test configurations
24 SmartClass E1 Tester User’s Guide
Managing test configurations
After specifying test settings, you can save the configuration, and then restore
it at a later time when you want to run a test using the same settings. You can
also view a stored test configuration to verify it matches the desired settings
before using it. If you no longer need the configuration, you can delete it.
Saving a configuration
To save a test configuration
1 If you haven’t already done so, launch your test application (see
“Launching an E1 test application” on page 28 ), and configure the test
(see “Specifying test application settings” on page 29 ).
2 On the Configuration menu, select Save/Restore-View .
A menu appears.
3 Select Save Config .
A screen appears prompting you for a filename for the configuration file.
4 Enter a filename, and then press OK .
The configuration file is saved.
Restoring a configuration
To restore a saved test configuration
1 On the Configuration menu, select Save/Restore-View .
A menu appears.
2 Select Restore/View .
A menu appears listing all saved configurations.
3 Use the up and down arrows to highlight the configuration you want to
restore, and then the right arrow.
The configuration is restored.
Viewing a configuration
To view a saved test configuration
1 On the Configuration menu, select Save/Restore-View .
A menu appears.
2 Select Restore/View .
A menu appears listing all saved configurations.
3 Use the up and down arrows to highlight the configuration you want to
restore, and then press
OK .
The configuration is displayed on the screen.