Chapter 7
Testing with SmartIDs
Coax Map test
OneExpert DSL User’s Guide
April 2014
22052280, Revision 001
55
This registration applies to the SmartID that the OneExpert DSL is physically connected to.
You will need to repeat the procedure for each SmartID, connecting it directly to the
OneExpert DSL.
a
If the Registration doesn’t automatically come up, select the
Actions
system key and
then touch
SmartID Registration.
b
Do one of the following:
–
Use the up and down arrows to highlight the label letter for the SmartID and then press
OK.
–
Touch the letter for the SmartID
c
Plug in the SmartID or enter the serial number (if the SmartID is plugged in, it will adver-
tise its serial number to the OneExpert DSL).
d
Repeat
for each SmartID.
The SmartIDs are registered.
4
If the test doesn’t automatically start, press the
RESTART
system key.
The test runs and then displays the IDs found.
5
To enter Fast-Scan mode, press the SCAN system key.
The Locate SmartIDs test performs a single locate function. Fast-Scan mode continuously
scans for connected SmartIDs to allow you to quickly identify multiple coax runs in succes-
sion.
6
Use the
SAVE
system key to save the results to the job file.
Coax Map test
The purpose of this test is to map out the topology of a coax network, from a single point, without
having to perform a two ended test using far end devices. This measurement can be used to locate
devices in a coax cable such as barrels, splitter, and splices.
To run a Coax Map test
1
Connect to a SmartID Plus using Bluetooth.
2
On the SmartID menu, select S
ingle Ended Coax Map
.
The Coax Map screen is displayed.
Select the Mode system key and specify a Map Mode.
–
Single Ended Coax Map
–
Dual Ended Coax Map
–
VDSL Home Run Check
–
Whole Home Check (No Diplexer)
–
Whole Home Check (Through Diplexer)
Summary of Contents for OneExpert DSL
Page 1: ...OneExpert DSL User s Guide...
Page 2: ......
Page 16: ...About this Guide Conventions OneExpert DSL User s Guide xiv 22052280 Rev 000 April 2014...
Page 119: ......
