Chapter 4 IP Testing
Selecting a layer 3 IP test
120
HST-3000 Ethernet Testing User’s Guide
Selecting a layer 3 IP test
IPv4 and IPv6 applications are available for layer 3 IP testing.
You must select an IPv4 test application if you intend to:
– Establish PPPoE sessions on electrical circuits.
– Transmit and analyze MPLS encapsulated traffic over
electrical or optical circuits.
To select a layer 3 IP test
1 Do one of the following:
– If you haven’t already done so, launch the application
for the circuit you are testing (see
), and then proceed to
.
If you are testing a circuit carrying IPv4 traffic, be
certain to launch the application using the ETH ELEC
or ETH OPTIC softkey.
If you are testing a circuit carrying IPv6 traffic, be
certain to launch the application using the IPv6 ELEC
or IPv6 OPTIC softkey.
– If you already launched your application and selected
a test, but you want to change the test, go to the Test
Mode menu, and then select the Test setting.
A list of tests for the application appears.
2 Highlight and select one of the following:
– Layer 3 IP Traffic. Select this test to transmit or
analyze standard layer 3 traffic.
Error Messages
ICMPv4 messages appear in
the Message result category.
ICMPv6 messages appear in
the Message result category.
Table 10
IPv4 and IPv6 applications (Continued)
Feature
IPv4
IPv6
Summary of Contents for IP Video Test Option HST-3000
