1248090_Rev1.0
230START/230SOCKET
Page
1/2
230START / 230SOCKET
User’s manual
Technical data
230Vac–1000VA plug controlled by radio.
Frequency 868,35MHz
Coding
High security rolling code
Memory 30
codes
Number of relays
1 relays
Supply
230V ac (+/- 10%)
Relay contacts
10A
Consumption Max
32mA
Op. temperature
-20ºC to +55ºC
Watertightness IP22
Size 58,5x104,50x50mm
(without
plugs)
Starting up
Mechanical installation
Connect the wired output (230START only).
It is recommended to program the receiver before installing (especially if the final location has difficult access).
Manual programming
Press the receiver programming button for 1 second and an acoustic signal will be heard and the led will turn on. The receiver will enter
programming. Press the transmitter to be programmed. Every time a transmitter is programmed, the receiver will issue an acoustic signal
for 0.5 sec. After 10 seconds without programming or pressing the first two transmitter buttons, the receiver will exit programming mode,
issuing two acoustic signals of 1 sec. If upon programming a transmitter the receiver memory is full, it will issue 7 acoustic signals of 0.5
seconds and exit programming.
Total reset
In programming mode, press the reset button with a paperclip (or similar). The receiver will issue 10 short acoustic warning signals
followed by others at a faster pace to indicate that the operation has been successful. The receiver is now in programming mode.
After 10 seconds without programming or quickly pressing the programming button, the receiver will exit programming mode, issuing two
acoustic signals of 1 sec.
Operating
The led are activated every 5 seconds to indicate the correct supply of power to the equipment.
230START:
Upon receiving a code, the receiver checks whether it is in its memory, activating the wired output in an impulsional way. The 230V
output plug is always on.
230SOCKET:
Upon receiving a code, the receiver checks whether it is in its memory, activating the 230V output plug in a biestable way.
