Programming of one safety transmitter (IN1 input)
Mode
Configuration of transmitter programming
in the receiver.
Led R1
Led R2
1
Safety edge activates relay 1 on the
receiver
ON
OFF
2
Safety edge activates relay 2 on the
receiver
OFF
ON
3
Safety edge activates the two relays 1 and 2
at the same time
ON
ON
Programming of two safety transmitters (IN1 and IN2 input)
4
Safety edge in IN1 activates relay 1 and
safety edge in IN2 activates relay 2
Flashing
Flashing
Check the correct operation
It is recommended to verify the installation while the leds are active. Each press of
PROG button activates the leds for 5 minutes.
Press each safety edge connected to assure that the appropriate relay on the receiver
is activated.
If not, see the Leds and Beeps indication table, to check what is happening and how
to solve it.
jcm
technologies
9
Summary of Contents for RB3 TGL868
Page 1: ...RB3 TGL868 User Manual...
