jcm-tech RB3 T868, User Manual

Page: 32 / 84

Introduction
Operating
The RadioBand system is designed for Domestic, Commercial and Industrial door
and gate applications where a safety edge is used.
The system provides a wireless system replacing spiral cables or energy chain sys-
tems to provide the safety signal to the door or gate control panel.
The receiver continuously monitors the status of transmitters connected to it. The
system performs a complete test of the equipment, including radio communication,
every 7 seconds.
With the system you can support 8,2 KOhm safety edges and also optical low power
systems. Additionally you can connect slack ropes and wicket doors in the 8k2 input.
The signal will be transferred by radio.
When an obstacle is detected, the RadioBand system turns its output in a safety
state, changing the state of the receiver relay.
Up to three transmitters per output can be connected to the receiver. There are two
outputs on each receiver that can be connected to the control panel as 8k2 or NC (nor-
mally closed) contact.
The system complies with EN ISO 13849-1:2015, category 2, PLd. Certified by TÜV
NORD CERT GmbH.
jcm technologies
4