jcb JS 200 Series, Service Manual

Page: 40 / 531

5 - 8
Changing the Air Breather Element
1. Prepare the Machine
Position the machine on level ground. Stop the engine.
Remove the Starter Key.
2. Release Tank Pressure
See Releasing Tank Pressure .
3. Locate the Air Breather Element
See Identification of Machine Components .
4. Replace the Air Breather Element
a. Remove first the hexagonal nut A , seal washer B
and cover C .
Note: The cover C can only fit in one of two positions
because of the slot G in the cover which locates over a
similar shaped protrusion on the mounting stud.
b. Remove the old filter element D together with the
sponge packing E .
c. Replace the old filter element D , with a new one.
When installing the new filter element D place the
sponge packing E on the element.
5. Refit the Filter cover C
a. Adjust the cover so that it fits over the stud, and
install in the following order: Seal washer
B ,
hexagonal nut A and box nut F .
Section 3
Routine Maintenance
9803/6400
Section 3
5 - 8
Issue 2*
Hydraulics (continued)
JS03660
F
B
A
G
C
E
D
H
A
*
*
*
*
*
*
*
*
*