34
VTX A
8
| Rigging Manual
8.10 - ATTACHING THE ARRAY FRAME
Below are the required steps to attach the VTX A8 AF to a stack of four VTX A8 enclosures.
STEPS:
• To make it easier to attach, separate the Array Frame from the Extension Bar.
• Ensure that the top cabinet is set to the
4 Degree
angle and ensure that the Array Frame is oriented in the proper direction. Lift
the frame over the top A8 cabinet on the cart and place it resting on the four QRP attachment points on the top of the cabinet.
• Remove the QRP’s from their storage positions and place each one into its respective attachment position. The QRP’s should
be attached from the inside of the Array Frame.
• Once the Array Frame is secured to the top of the cabinet, the Extension Bar can be attached. Confirm its correct orientation
by consulting the LAC and ensure that the correct A, B or C position is attached using both of the included large-gauge QRP’s.
1
2
3
4
Note:
The QRP’s connecting the array frame to the first A8 or B18 cabinets are mounted from the inside of the frame as shown below.
The QRP lanyards are not long enough to reach to the outside positions.
3
2
4
Pin Position:
4°
