30
31
Clean periodically
Maintenance
1.
Connect the tool to the station port by means of the Converter.
2.
Connect your Robot system to the Robot connector (RJ12) of the station.
DB9-RJ12 Adapater available only if necessary (Ref: 0013772).
3.
Enable the Robot option in the station settings and the notification will be displayed:
4.
Set your Robot’s commands according to the Robot Communication Protocol, available on the
website
www.jbctools.com/jbcsoftware-menu-115.html
.
Manage and monitor the station using a Robotic system.
Working with Robots
Control
Unit
Robot
Update the station software
1.
Download the JBC Update File from
www.jbctools.com/software.html
and save
it on a USB flash drive. Preferably one with
no other files.
JBC
Update File
Before carrying out maintenance or storage, always allow the equipment to cool.
- Clean the station screen with a glass cleaner
or a damp cloth.
1.
Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
2.
Press the new fuse into the fuse holder
and replace it in the station.
- Use a damp cloth to clean the casing and
the tool. Alcohol can only be used to clean
the metal parts.
- Periodically check that the metal parts of
the tool and stand are clean so that the
station can detect the tool status.
Fuse holder
Fuse holder
- Maintain tip surface clean and tinned prior
to storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat
transfer to the solder joint.
- Periodically check all cables and tubes.
Converter
Ref. 0002747
2.
Insert the USB flash drive to the station.
The icon is diplayed while updating.
Fuse
RS-232
connection
- Replace a blown fuse as follows:
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
www.jbctools.com
