ENGLISH
OPERATION
MANUAL
JB SYSTEMS®
5/72
SPACE-1 Laser
16. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to
fix a mounting hook.
17. Laser output
18. WARNING LABEL: “Caution – Class 3R laser. Laser Radiation when open. Avoid
direct eye exposure.”
19. WARNING LABEL: “Laser Aperture”
20. WARNING LABEL: “Laser warning sign”
21. WARNING LABEL: “Laser Radiation. Do not stare into beam or view directly with
optical instruments. Class 3R laser product. According to EN60825-1:1994 + A1:2002.
Wavelength = 532nm, Speed = 43,776mS, Scan Angle = 68,4°”
22. TYPE PLATE: serial number, etc.
OVERHEAD RIGGING
•
Important:
The installation must be carried out by qualified service personal only.
Improper installation can result in serious injuries and/or damage to property.
Overhead rigging requires extensive experience! Working load limits should be
respected, certified installation materials should be used, the installed device
should be inspected regularly for safety.
•
Make sure the area below the installation place is free from unwanted persons during
rigging, de-rigging and servicing.
•
Locate the fixture in a well ventilated spot, far away from any flammable materials and/or
liquids. The fixture must be fixed
at least 50cm
from surrounding walls.
•
The device should be installed out of reach of people and outside areas where persons
may walk by or be seated.
•
Before rigging make sure that the installation area can hold a minimum point load of
10times the device’s weight.
•
Always use a certified safety cable that can hold 12times the weight of the device when
installing the unit. This secondary safety attachment should be installed in a way that no
part of the installation can drop more than 20cm if the main attachment fails.
•
The device should be well fixed; a free-swinging mounting is dangerous and may not be
considered!
•
Don’t cover any ventilation openings as this may result in overheating.
•
The operator has to make sure that the safety-relating and machine-technical
installations are approved by an expert before using them for the first time. The
installations should be inspected every year by a skilled person to be sure that safety is
still optimal.
CAUTION EYEDAMAGE:
Always position the laser in a way that
prevents the audience from looking directly into the laser beams. The
installation should assure that the beam will not strike the audience.
ENGLISH
OPERATION
MANUAL
JB SYSTEMS®
6/72
SPACE-1 Laser
HOW TO SET UP THE UNIT
CONTROL PANEL:
MAIN MENU:
•
To select any of the pre-set
functions, press the
MENU
button up to when the
required one is shown on the
display.
•
Select the function with the
ENTER
button. The display
will blink.
•
Use
DOWN
and
UP
button to
change the mode.
•
Once the required mode has
been selected, press the
ENTER
button to select. After
8 seconds the display will
automatically return to the
main functions without any
change. To go back to the
functions without any change
press the
MENU
button. The
main functions are shown on the right.
DMX512 Address Setting
Used to set the starting address in a DMX setup.
•
Press the MENU button until
is shown on the display.
•
Press the ENTER button, the display starts blinking.
•
Use DOWN and UP buttons to change the DMX512 address.
•
Once the correct address shows on the display, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
