ENGLISH
OPERATION MANUAL
JB SYSTEMS®
3/57
MICRO/MINI LED MANAGER
FUNCTIONS
MICRO LED MANAGER MK2
Mini LED Manager Mk3
1. INTERNAL MICRO:
used for sound activated chases.
2. DMX INPUT:
3pin male XLR-connector used to connect universal DMX-cables. This input receives
instructions from a DMX-controller or from another Micro / Mini LED Manager when used in master/slave
mode.
3. DMX OUTPUT:
3pin female XLR-connector used to connect the Micro LED Manager Mk2 with the next
DMX appliance in the chain or with another Micro / Mini LED Manager when used in master/slave mode.
The Micro / Mini LED Manager can also be used as controller for other LED projectors like for example
“LED PAR56/64”
4. POWER ON LED:
used to check if the Micro / Mini LED Manager is connected to the mains.
5. DIP SWITCHES:
when used in DMX mode (DIP10 = OFF) you can set the DMX-starting address of the
unit. When used in stand-alone mode (master, DIP10 = ON), you can use the DIP-switches to set
different pre-programmed options.
6. AUTO DMX ADDRESS BUTTON:
see further to learn how to set the DMX address easily.
7. OUTPUT TERMINALS:
used to connect different 24Vdc common anode LED projectors. You can
connect any 4pole electrical wire to connect the LED-projectors to this output. However to make life
easier for you we suggest using the special CCM-50 cable (role = 50m). The wires in this cable
correspond to the colors of the LEDs
.
8. ANALOG SWITCH INPUT:
used to connect any external analog switch. This external switch can be
used to switch the general output of the Micro / Mini LED Manager on/off. (external blackout)
See
further for more information on how to connect the analog switch.
9. WALL DIMMER INPUT:
used to connect our LED WALL DIMMER, a small LED controller that fits in any
standard “electrical wall box”.
See further for more information on how to connect the LED WALL
DIMMER.
10. MAINS INPUT:
with IEC socket, connect the supplied mains cable here.
11. STATUS LED:
shows the status of the unit, should blink when DMX is detected.
