Jayco Precept 2018, Owner'S Manual, Page: 84 / 169

82
Section 6: Electrical System
Controls and Switches
Your motor home is equipped with various switches and controls that allow you to operate
and monitor the systems in your motor home.
Information on these controls and their location will be provided throughout this manual.
Additional information on the various components can be found in the component
manufacturer’s user guide.
Command Center
The command center is typically located inside the entrance door
or in the living area of the RV, and contains switches and controls
for various electrical functions. Command center applications,
configurations and components will vary by model.
Command Center Panel or Command Center Panel with
Switch Modules
Items found on these panels may include:
Fuel gauge and hour meter with switches for fuel pump and
fuel levels; fuel station (if so equipped) on/off switch
Lighted red pump and water heater switches (electric & LP
gas)
Generator start / stop switch; may include hour meter
Tank heater switchesLight switches for porch lights, exterior
security lights, interior lights, awning LED lights, front cap
LED accent lights, power entry step
Cargo bed red lighted control switch
Slideout control switches (press and hold to extend / retract)
Awning control switches (press and hold to extend / retract)
Systems monitor with LED indicators for tank levels and
battery charge status
Auto leveling control panel (for leveling the RV)
Inverter panel (power switch with display)
Power bunk bed lift control switch
Speaker selector switch
Command Center Modules Mounted to the Wall
Some models may have the modules mounted directly to the
interior wall of the vehicle. They are typically located near the
entrance door.Touch Dimmer Switch:
Touch Dimmer Switch:
Certain models may include a touch dimmer switch next to the
Command Center panel. (There are no interior light switches on the
Command Center panel).
●
Turn ON ceiling lights: Tap the LED light on the dimmer
●
Turn OFF ceiling lights: Tap the LED light on the dimmer
● Dimmer: If lights are off, hold finger on the LED light and
lights will begin turning on gradually until fully lit. If lights are
on, hold finger on the LED light and lights begin to gradually
turn off.
Command Center Panel
W/Switch Modules
Command Center Panel
Table of Contents Maintenance Record