
151
Section 12: Interior
Privacy Drape Installation
1.
Starting on the driver’s side, attach the black plastic hook to the loop on the wall
(behind the driver’s seat). Make sure the Velcro® on the drape is facing the motorhome
windshield.
2.
Pull the drape towards the windshield and past the driver’s side sun visor. Open the sun
visor against the windshield to hold the drape in place.
3.
Continue across the windshield to the passenger side, again opening the sun visor and
placing the drape behind it.
4.
Attach the black plastic hook on the passenger side of the drape, to the loop on the wall
behind the passenger’s seat.
5.
Attach the Velcro® at the top edge of the drape to the corresponding Velcro® on the cab
area roof (above the driver’s and passenger’s doors).
6.
Attach the Velcro® at the bottom corners of the drape to the corresponding Velcro®
on the wall.
Bed Storage
Additional storage has been provided under the bed. It is equipped with gas struts to assist
with easy access. To access the storage area, grasp the end ledge at the foot of the bed
and lift carefully. To close, carefully push down on the bed slowly easing it to the closed
position.
The bedroom electric slide room system may be located under the bed. Use care not to
obstruct the slide room system when using the under bed storage area.
Before lifting, be sure there is nothing on the bed that will restrict its movement
or add extra weight. Use caution when opening or closing the bed to keep
hands and fingers at the end ledge provided (not on the side or further back
than necessary) to avoid pinch points.
Cab-Over Bunk Bed (If So Equipped)
The storage position for the bunk is near the ceiling. Any time the bunk is raised into the
storage position, the seat belt style interlock
(Fig 1)
located at the left end of the bunk, must
be latched. The interlock belt, when latched, disables the key switch, and the bunk cannot be
lowered/raised even if the key switch is ON.
Lowering the bunk:
To lower the cab-over bunk; unlatch the interlock belt
(Fig 1)
(it
operates just like a seat belt), insert the key into the key switch (on the left end of the bunk)
(Fig 2)
, and turn it to the right to the ON position
(Fig 3)
. Lower the bunk by pressing and
holding the yellow down arrow under the picture of the bed on the key switch label. The
bunk automatically stops when it is fully lowered. Return the key to the OFF position.
Table of Contents
Maintenance Record
Summary of Contents for Precept 2018
