Jayco GRANITE RIDGE, Owner'S Manual

Page: 29 / 134

set up correctly. The corners of this seal are cut at a 45° angle. The top of the seal must
overlap the side of the seal to avoid the possibility of water penetration. (Fig. 3-8)
Operations
IMPORTANT SLIDEOUT INSTRUCTIONS
• Remove transit bars (Fig. 3-9) from the top of
slideout before operating slideout. When slideout
is in, insert the transit bars on top of the slideout
before traveling.
• Models with a slideout front dinette seat are equipped with a tie down strap. Make sure this
strap is removed when opening the slideout. It is also critical to reinstall the strap prior to
travel once the slideout is retracted.
EXTENDING ROOM
1. Battery(ies) must be fully charged and connected. The motorhome should be hooked up to
120-volt AC power if possible.
2. Turn the motorhome master battery switch on.
3. The motorhome must be level and if the unit has stabilizer jacks they must be in the down
position.
I
CAUTION: Additional support jacks are not needed under the slideout. Damage can occur
to your slideout room from improper use of support jacks.
4. Remove the "transit bars" from behind the top fascia board located above the slideout room.
5. For models with a slideout front facing dinette seat, remove the tie down strap on the aft end
of the rear dinette seat.
6. Ensure that there are no items left between the slideout and cabinetry.
7. Locate the slideout master control switch.
8. To move the room out, press the "out" button on the switch and hold it until the motor stops.
9. Release the button. Travel time - approximately twenty seconds.
RETRACTING ROOM
1. Remove all objects from in front of the room.
2. Press the "IN" button to bring the room in and hold it until the motor stops.
3. Release the button.
4. Install the "transit bars" in the proper location as indicated on the wall.
5. Install the rear dinette seat tie down strap, if applicable.
Operating and Using Your Type C Motorhome 21
Fig. 3-9
Fig. 3-8