![background image](http://html1.mh-extra.com/html/jayco/embark-2022/embark-2022_owners-manual_3570511042.webp)
36
Section 4: Vehicle Operation
The entrance screen door may be equipped with a slide panel that allows access to the en-
trance door handle and locks. The entrance door may also be equipped with both a regular
door lock and a dead bolt lock.
Keys
Several keys are provided when you purchase your vehicle. Most keys have an individual
key number stamped on the plate. Record these key numbers and keep the information in a
safe place. You can order a key blank from your dealer to have duplicate keys made. If you
lose the keys, contact your dealer or a locksmith for assistance.
NOTE:
Locks on entrance and baggage doors need biannual lubrication
using a light coat of silicone spray. Conditions such as rain, salt, dust and
pollution may increase the maintenance needs.
Keyless Entry
The keyless entry system allows a secure method to lock and unlock the en-
trance door. The keypad located next to the entrance door controls the keyless
entry system. Programming your own personal
Authority Code
into the sys-
tem will prevent unauthorized entry into your motor home by those who may
know the factory default code. If a correct code is not entered after 20 button
presses, the keypad will disable button recognition for one minute. This fea-
ture will prevent unauthorized access by entering random codes
Authority Code
The Authority Code is a unique 5-digit pass code that gives the system administrator (or
owner) the ability to program transmitter key fob’s and keypad access codes. The Authority
Code does not allow for secure operations (like locking the door). It is only used to assign
Access Codes. Retrieve the keypad Authority Code from the keyless entry system manual.
If the keyless entry Authority Code is still set to the factory default, it should be changed for
security purposes.
The
default Authority Code
=
Five presses of the (7/8) button on the keypad.
Assigning a new Authority Code (required to assign a new Access Code)
1. Access the program wires located in the dash compartment on the passenger side of the
motor home. Remove the (woodgrain) tray on the dash, by pulling up on the tray. It is
held in place by either Velcro or plastic clips.
NOTE:
An
Access Code
is not required to lock the doors.
Press and hold the (1/2) button. The keypad will beep and
doors will begin to lock after two seconds.
NOTE:
You will need a paperclip to use for programming the key pad.
Table of Contents
Maintenance Record
Summary of Contents for Embark 2022
