105
Section 8: Plumbing System
4.
Using a spanner wrench, rotate the filter housing. Unscrew the hous
-
ing completely, dump water out and remove the filter (dispose of the
old filter properly).
5.
Clean the inside of the filter housing with mild detergent. Thorough
-
ly rinse and wipe clean.
6. Remove the O-ring from the groove in the housing and wipe clean.
Coat with petroleum jelly.
7. Replace the O-ring in the groove, making sure it is properly seated.
8.
Install the new filter cartridge.
9.
Replace the canister housing (hand tighten is normally sufficient).
10. Turn on the water supply, turn the pump ON, open a faucet and check
for leaks. Turn the pump OFF afterwards.
Each new recreational vehicle is winterized with RV antifreeze before it is shipped to the
dealer. To use the water purification system, full system canister water lines need to be
flushed of antifreeze and then the filter installed in the canister before use.
Refer to the manufacturer’s owner’s manual and the label on the water filter cartridge for
further information.
Filter Housing
NOTE:
There is
no bypass
feature on a canister style water filter. The
water filter must be removed
before sanitizing or winterizing
the RV.
Do not allow water in the canister housing to freeze.
Remove the filter before using anti-freeze to winterize the system or
chlorine solution to sanitize the system.
Flush canister housing thoroughly before it is put back into service after
winterizing or sanitizing.
For best results replace filter every 6-12 months.
Do not use carbon cartridges where water is microbiologically unsafe or
of unknown quality.
Maximum operating pressure is 125 psi (8.75 bar).
Maximum water temperature is 125° F (52° C).
Draining the Fresh Water System
Water tanks may be drained through a valve located near the tank. A recreational vehicle
with a demand pressure pump system will have low-point drains attached to the water lines
(normally located near the water tank).
These low-point drains will release water in the supply lines by opening the valves and all
faucets. The water heater has its own drain plug. To drain the permanent fresh water holding
tank and supply lines:
1.
Turn the water heater power OFF (turn off the electric and LP gas switches).
2. Open all faucets, including the outside shower faucet (if so equipped).
3. Open the “fresh tank drain” valve. All fresh water tanks can be drained by one of two
types of drain valves. A white plastic drain is attached to the exterior wall or a valve
Table of Contents
Maintenance Record
Summary of Contents for Alante 2021
