AAA-055-00138
Rev. 1/14/15
Jaylor Owner Manual
- 25 -
Mini Mixer Models
10.5 A50 Truck Mounted (CE Stationary) Mixer Components
Figure 22 - A50 Truck Mounted Mixer Components
1. Mixer Drum
– Used to contain the feed
while it is cut and mixed by the vertical
auger.
2. Vertical Auger
– Used to mix the feed
within the mixer drum and to discharge the
feed through the unloading door.
3. Auger Knives
– Used to cut the feed
material as the auger rotates.
4. Battery
– Provides power to the electric
engine starter, electronic scale system, and
auxiliary components (if applicable).
5. Control Pendant
– Controls door opening
and auger on/off.
6. Hydraulic Oil Reservoir/Cap
– Remove
this cap to add oil. Dipstick indicates
proper oil level range.
7. Electronic Scale Indicator –
Displays the
weight inside the drum.
8. Unloading Door
– Door can be opened to
allow feed to be discharged.
9. Tie-Down Brackets
– Used to secure
mixer to transport vehicle.
10. Fuel Tank/Cap
– Remove this cap to add
fuel.
11. Engine Start Key*
12. Engine Oil Dipstick*
13. Engine Choke*
14. Foot Safety Switch
– Equipped on CE
units. When auger is rotating, the foot
safety switch must be depressed before
unloading door is opened. If not, auger will
stop rotating. This switch works in
conjunction with ‘
15. Door Safety Switch
’.
15. Door Safety Switch
– Equipped on CE
units. When unloading door is opened, this
switch is activated. At this time, ‘
14. Foot
Safety Switch
’ must be depressed or the
auger will stop rotating.
* - On CE Stationary units, engine is replaced with an electric motor. In this case, power supply
cover will also differ.
