Javad TriPad, User Manual

Page: 9 / 10

Keys and LEDs
NVRAM clearing with TriPad
9 www.javad.com
4. NVRAM clearing with TriPad
It is possible to clear NVRAM using only TriPad. To do that:
• Turn the receiver OFF.
• Press and hold FN button.
• Press and release PWR button to turn the receiver ON.
• Wait until both LEDs will light green.
• Wait around five seconds, until both LEDs will blink orange.
• Release FN button.
Note that LEDs will blink orange only during next five seconds, and to clear NVRAM it is essential to
release FN button when they blink yellow.
When data recording is ON, and the FN key is...
Not pressed Red No free memory; hardware problem with data recording.
If FN key mode is «LED blink mode switch»
Green Data recording started (post-processing occupation mode undefined).
If FN key mode is «Occupation mode switch»
Green Data recording started (Kinematic post-processing occupation mode).
Orange Data recording started (Static post-processing occupation mode).
Pressed for < 1 second If FN key mode is «LED blink mode switch»
Orange Release to change information mode.
If FN key mode is «Occupation mode switch»
Orange Release to toggle between Static and Kinematic post-processing modes.
Pressed for 1–5 No light Release to stop data recording.
Pressed for 5–8 seconds Red Release to turn serial port A baud rate to 9600 bps.
Pressed for > 8 seconds No light No function (data recording still on).
FN Key REC LED Status