Javad Maxor, User Manual

Page: 115 / 142

www.javad.com Maxor User’s Manual 5-7
TR O U B L E S H O O T I N G
Bluetooth Problems
Bluetooth Problems
The following are some of the most commonly encountered error messages.
BTCONF reports the error messages in the status bar.
The receiver does not start data logging.
Causes Solutions
The receiver has
already logged 512
files into the internal
memory.
• Delete unnecessary files (see “Deleting Files” on
page 4-10).
• Use the AFRM feature. See “Automatic File Rotation
Mode (AFRM) parameters” on page 2-18.
Problem
Error Message
Can’t find receiver.
Causes Solutions
The receiver is turned
off. Ensure the receiver has power and is turned on.
If using a cable, the
cable’s connectors are
improperly attached.
• Check that the cable connector is attached to the correct
serial port.
• Unplug the cable, then securely and properly reconnect
it to the receiver.
If using a cable, the
cable is damaged.
• Use an undamaged cable.
• Contact your Dealer to purchase a new cable.
The COM port the
receiver is attached to
differs from the one
selected in BTCONF. Ensure that the RS232 cable is attached to the COM port
specified in the BTCONF communication port dropdown
list. See “Bluetooth Module Configuration” on page 2-31
for details.
The receiver port used
for connection is not in
Command mode.
1.
Connect your receiver and a computer using a free port
(see“Connecting the Maxor and a Computer” on
page 2-8) and start PCView.
2.
Click Configuration->Receiver->Ports .
3.
Change the Input for the serial port used for connection
to Command.