42
LGG100-GG Operator’s Manual
www.javad.com
S E T U P A N D M E A S U R I N G
LGG100-GG Setup
3
LGG100-GG Setup
Follow steps 1 through 3 to setup your receiver.
Step 1
Set up Receiver
This section assumes you have already configured your receiver using PCView.
1.
Place the LGG100-GG on the appropriate position.
2.
Center the receiver over the point at which data will be collected. For most
applications, this should be at a location with a clear view of the sky.
Step 2
Antenna Setup
The LGG100-GG is used with an external antenna. Follow the steps below to
connect an external antenna to the LGG100-GG and measure its offset.
1. Attach the antenna to a tripod or bipod and center it over the point at
which data will be collected.
2. Measure the antenna height. Antennas have two types of measurements:
• Vertical - measured from the marker to the antenna reference point
(ARP) located on the bottom of the antenna at the base of the mounting
threads.
• Slant - measured from the marker to the lower edge of the antenna's
slant height measure mark (SHMM).
antenna offsets are shown in Figure 3-1 on page 43;
Offset measurements for this antenna is given in Table 3-1 on page 43.
