Javad HPT225BT, Operator'S Manual

Page: 15 / 48

Chapter 2
15 www.javad.com
C
ONFIGURATION
1. Powering HPT225BT
To power HPT225BT use the Battery kit 2 (p/n 99-587100-10).
Figure 1. Battery Kit 2
Warning: Powering HPT225BT please observe polarity!
1.1. Power supply requirements
A single external power supply is necessary to operate HPT225BT. The external power supply needs to
be Listed for US and Certified for EU countries, it needs also to be a Limited Power Source and rated for
Outdoor Use and have an output rated for +9... +16V, 10A. This may not be the same range as other
JAVAD GNSS products with which you are familiar.
C
AUTION
: To avoid the introduction of hazards when operating and installing, before connecting of the equip-
ment to the supply, make sure that the supply meets local and national safety ordinances and
matches the equipment’s voltage and current requirements.
C
AUTION
: Never attempt any maintenance or cleaning of the supply while plugged in. Always remove supply
from AC power before attempting service or cleaning.
Warning: If the voltage supplied is below the minimum specification, the modem will suspend operation. If the voltage
supplied is above the maximum specification, the modem may be permanently damaged, voiding your
warranty.
Make sure cords are located so that will not be stepped on, tripped over, or otherwise subjected to
damage or stress. Do not operate equipment with a damaged cord or plug – replace immediately.